Contents - Index - Previous - Next


Super-Scan Clicks Command  (Waveform Menu)

The source file is automatically scanned by Wave Corrector when it is first loaded. This command enables you to re-scan for clicks if the results of the original scan are unsatisfactory.

The command is similar to 'Re-Scan Clicks' except that the original corrections are not removed before re-scanning, the new corrections being superimposed upon the existing corrections.

If you have a very crackly recording, set the number of passes of super-scan to a value greater than one. Each pass of the super-scan detector removes residual clicks.

Selecting the command activates a dialogue box for entering new scanning parameters.

Track markers are unaffected when you use this command. 

Selecting the command activates a dialogue box for entering new scanning parameters. See the Options Dialogue for descriptions of the detection parameters available 

Note: You cannot use this command after digital filtering has been applied (eg the hiss filter). Therefore, make sure your click corrections are satisfactory before applying any digital filters. Alternatively, you can use the Remove Filtering command to restore the Re-scan Clicks capability.